Round Polypropelene Pavement Markers
Our round polypropelene pavement markers are manufactured per ASTM specifications. The bottom of these pavement markers are configured to produce an excellent structural bond with the pavement. Non-reflective road marker 4 inches in diameter.
948 Series Reflective Pavement Markers
The model 948 is an innovative glass-face marker for use on pavement. It is designed to meet today's changing highway and vehicle conditions. The 948 marker measures 4.7" long x 2.3" wide x 0.52" high. Markers can be applied with bituminous adhesive or conventional epoxy adhesive.
Martin 'Standard' Bituminous Adhesive
Bituminous Marker Adhesive is a hot
melt bituminous adhesive used to permanently bond pavement markers to Portland
cement concrete and asphaltic concrete.
- Superior Adhesion
- Superior Flexibility
- Superior Impact Resistance
'Swarco' Premium Glass Beads
Glass beads are the result of a recycling process which are taken from window manufacturers and is transformed in furnaces into round, clear spheres. The smallest beads are no bigger than a few thousandth parts of a millimetre.
• Super Bags
'Potters' Highway Safety Spheres
pavement marking lines make a significant contribution to highway safety, especially in conditions of poor visibility at night and in wet weather. Applying Potters Highway Safety Marking Sphere technology is one of the most cost-effective ways to increase highway safety in these conditions.
• Super Bags
'Dura Tec' Epoxy Adhesive Resin
epoxy resin provides great adhesive to surface areas. Two part epoxy, simply mix part A and B together. Quick drying times coupled with advanced hardening prove to be a winning combination.
Butyl adhesive pads are a quick and easy way to firmly adhere road reflectors, delineator posts, car stops, speed bumps and other traffic control devices to asphalt or concrete surfaces. Ideal where temporary mounting is required. Simply peel one of the release papers from the pad, apply the pad to the device, peel off the remaining release paper and firmly attach device to cleaned surface.
Parking Lot Stop
• Includes 5 pre-drilled holes for easy lag bolt mooring
• Temporary or permanent installation.
• Flexible: conforms to any asphalt or concrete surface.
• Less damaging to vehicles upon impact.
• Resistant to extreme temperature variations, UV light, oils, moisture and damage.
• All-weather easy maintenance: will not rust, chip, crack, crumble, corrode or need repainting.
'Impact Recovery Systems' Pedestrian Crossing
The In-Street Pedestrian Crosswalk Signs provide enhanced conspicuity at un-signalized intersections in order to alert motorists to local laws concerning yielding to or stopping for pedestrians in crosswalks.
'Impact Recovery Systems' Sta-Rite signpost
These signs utilize our reactive spring unit which allows the sign to withstand bumper hits and return to original position, without damaging the sign or vehicle. Ideal for high traffic parking lot locations,
This is commercial grade blacktop repair and is designed to repair potholes. It provides superior placement and bonding to produce a virtually permanent repair, even in cold, damp conditions.
* Use on roads, driveways, parking lots and pathways
* Repaired area is ready for immediate return to service
* Superior bond strength
* Use in wet or dry conditions
'Armorcast' Detectable Warning Panels
ADAAG COMPLIANT - Armorcast products meet all requirements set forth by the American Disabilities Act Accessibilities Guidelines and are approved by most municipalities and state DOT's. Out performs all traditional panels, clay, brick, composite or cement concrete domed products. Truncated domes will not shear or crack when exposed to high side impact loads or when installed in high traffic areas.